None 181975 Instruction Manual download pdf

Lay two of the horizontal rails across the pickets so the notched rails

line up with the grooves on the pickets (ﬁg. 3).

Using a non-marring rubber mallet, tap the horizontal rail, locking the

notched rail into the pickets. Repeat this process with the next notched

rail. Carefully ﬂip the panel over and install remaining horizontal rails as

outlined in the previous step.

Place gate jambs on both sides of the rails and place the hinges in the

center of the fence rail. Using the bracket as a guide, drill the three (3)

necessary ¼" holes for the bracket bolts. Repeat these steps for the

hinged brackets as well (ﬁg. 4). Ensure the rails are fully inserted in the

jamb before drilling. The bolts need to go through the jamb and rail to

function properly.

Slide the hinged bracket and bracket on the top and bottom of the gate

jambs. Attach hinges to jambs with the supplied through bolts. Connect

bolts with the supplied cap nuts. Ensure the gate is square before all

bolts are tight. When square, tighten all bolts with a 7/16" wrench.

6'X42" WINDHAM GATE

ASSEMBLY INSTRUCTIONS AND INSTALLATION TIPS

Step 1

Step 2

Step 3

Step 4

PLANNING: Prior to construction, check with your local regulatory

agency for special code requirements in your area. Contact your

utility supplier to locate and mark underground lines.

Careful planning and measuring of your fence project is essential,

as moving posts after the concrete sets is extremely difﬁcult.

NOTE: PicketLock

™

is a patent-pending technology that provides

a glue- and fastener-free connection between the pickets and

rails. You may spray soapy water onto components to help them

slide more easily into their corresponding channels. A non-marring

rubber mallet may also be used to gently tap components more

ﬁrmly into place.

Find a clean surface for gate panel assembly. Beginning with the

starter picket, lay all pickets in the same direction and connect them

so the tongue side ﬁts into the groove side (ﬁg. 1).

Place the groove of the top rail down ﬁrmly over the top of the pickets

and position rail so that it's ﬂush on both ends (ﬁg. 2).

7811.pdf

ﬁg. 1

7811.pdf

ﬁg. 2 ﬁg. 3

ﬁg. 4

Items you may need:

• Soapy water

• Non-marring

rubber mallet

• Wooden wedge

• Power drill

• 1/4" drill bit

• 7/16" wrench

• Shims

Actual size: 68-1/2"h x 42-1/2"w

1 2 3 4

Summary of Contents

Page 1 - 6'X42" WINDHAM GATE

Lay two of the horizontal rails across the pickets so the notched rails line up with the grooves on the pickets (ﬁg. 3).Using a non-marring rubber mal

Page 2 - Digging Post Holes

Measure to be sure you can install the gate to the post with approximately a 2" gap from the ground to the bottom of the gate. Align the rails on

Page 3 - 7811.pdf

Coloque dos de los barandales horizontales a través de las estacas de modo que los barandales con ranuras se alineen con las ranuras de las estacas (ﬁ

Page 4 - Instalación de la puerta

Mida para asegurarse de que puede instalar la puerta al poste con una brecha de aproximadamente 2" desde el suelo hasta la parte inferior de la p