None Ele-Flg2019HF- Mini Pallet Instruction Manual download pdf

FlagStone Installation Sheet

Pull all the agstones out of the package and look

for the different tab congurations – they are

“One,” “Two,” & “Three”. Start laying out the

pattern prior to commencing.

STEP 1

Align the straight edge sides together and make

sure the tabs are all in the center area.

STEP 2 (refer to diagram)

Line up the curved points to properly align the

center of our pattern. Make sure to line up the

tabs accordingly.

STEP 3 (refer to diagram)

Align grout joint using the clearly marked spacer

on the package. Cut out the spacer with scissors

and use to keep the grout joints equally spaced.

STEP 4 (refer to diagram)

Clean the surface with a wire brush or power wash,

to insure a clean surface.

STEP 5

Mix “Polymer Thin-set” as needed and apply with

a 1/2” notch trowel.

STEP 6

Apply agstones as pictured and rmly push them

into the thin-set. Allow thin-set to dry approximately

12 hrs prior to starting the grouting process.

STEP 7

Mix grout as selected and use sponge or grout

bag to apply and clean with water after. Allow

roughly 12 hours prior to walking on your new

agstone project.

STEP 8

STEP 2

STEP 3

STEP 4

FlagStone Installation SheetPull all the agstones out of the package and look for the different tab congurations – they are “One,” “Two,” & “Thr

No comments

None Ele-Flg2019HF- Mini Pallet Instruction Manual